If the e-cigarette battery is broken, it will not cause a short circuit of the mechanical rod. Vapor is the battery that can't be used when using the device everyday. As the energy device of the electronic cigarette, the safety of the battery is one thing we have to carefully consider. Here, Xiaobian first gives a player friend. A general use of the battery, that is, the battery with our use, not a strong skin often has a variety of broken skin.
Players and friends who have the first picture should not be taken lightly. There is the positive pole of the battery, which is the most problematic place for the whole battery. The friends who have the second picture can be relieved. There is the negative pole of the battery. Not only the "flat" that we can see every day is the negative pole, the whole battery body is the negative pole, so that place After the skin is broken, it is necessary to increase the contact of the negative electrode at most, which will not affect the safety of the whole battery. It is really too lazy to deal with it, and the tape emergency is a matter that can be recognized. Of course, it is only emergency, if conditions permit, thoroughly Handle it.
Then, before processing, I took off my clothes and showed them the positive structure of the battery.
The structure of the positive electrode of the battery can be seen very clearly. The small circular platform in the middle is the positive pole of the battery. Aside from the small circular platform, the next turn is already the negative pole. So if we make a wire touch the positive platform of the battery, and then touch the small circle next to it, the battery will be short-circuited, and it will be dangerous! Therefore, battery manufacturers have added a layer of protection in order to avoid this kind of misuse that is likely to occur.
Everyone pays attention to seeing a small white circle, and it may be other colors. The role of this little thing is to insulate! In order to prevent the battery skin of the positive electrode of the battery from being damaged, it is dangerous to directly contact the metal with the positive and negative electrodes. This is the second barrier to the danger of the battery (the first barrier is the battery skin and the third barrier is the safety valve), so we must not throw this small circle!
Then we started to deal with it, we changed it to a dress! Is such a battery skin
1 first step
We completely tear off the broken battery skin, open the Hulk and plug the battery into the battery skin!
2 second step
We adjust the battery up and down, so that the length of the battery skin is almost the same!
3 third step
Take out the heat gun or hair dryer, adjust the mode of blowing hot air, hold the battery skin and start blowing. It is recommended to blow the negative electrode first!
4 fourth step
Continue to blow, blow the positive electrode, the battery skin will shrink due to the hot air. Remember to hold the small circle at the positive pole of the battery. This is just a display. Everyone should hold the nail while blowing. The temperature is not too high. High blow, wait for the contraction, then close your hand to ensure that the small insulation ring is in place!
5 fifth step
Stand up the battery or put it on the ground and start blowing the side of the battery!
Get it all, so the battery will be completely new!